Displaying And Maintaining Cluster Configuration; Cluster Configuration Examples; Basic Cluster Configuration Example - H3C S3100-52P Operation Manual

Operation Manual – Stack-Cluster
H3C S3100-52P Ethernet Switch

2.3 Displaying and Maintaining Cluster Configuration

Display all NDP configuration
and running information
(including the interval to send
NDP packets, the holdtime,
and all neighbors discovered)
Display NDP configuration and
running information on
specified ports (including the
neighbors discovered by NDP
on the ports)
Display global NTDP
information
Display device information
collected by NTDP
Display status and statistics
information about the cluster
Display information about the
candidate devices of the cluster
Display information about the
member devices of the cluster
Clear the statistics on NDP
ports
Note:
When you display the cluster topology information, the devices attached to the switch
that is listed in the backlist will not be displayed.

2.4 Cluster Configuration Examples

2.4.1 Basic Cluster Configuration Example

I. Network requirements
Three switches compose a cluster, where:
An S3100-52P switch serves as the management device.
The rest are member devices.
To do... Use the command...
display ndp
display ndp interface
port-list
display ntdp
display ntdp device-list
[ verbose ]
display cluster
display cluster candidates
[ mac-address H-H-H |
verbose ]
display cluster members
[ member-number | verbose ]
reset ndp statistics
[ interface port-list ]
2-22
Chapter 2 Cluster
Remarks
Available in any
view.
Available in user
view.