Qos Configuration Examples; Configuration Example Of Traffic Policing And Line Rate - H3C S3100-52P Operation Manual

Operation Manual – QoS-QoS Profile
H3C S3100-52P Ethernet Switch

1.6 QoS Configuration Examples

1.6.1 Configuration Example of Traffic policing and Line Rate

I. Network requirement
An enterprise network connects all the departments through an Ethernet switch. PC 1,
with the IP address 192.168.0.1 belongs to the R&D department and is connected to
Ethernet 1/0/1 of the switch. The marketing department is connected to Ethernet 1/0/2
of the switch.
Configure traffic policing and line rate to satisfy the following requirements:
Set the maximum rate of outbound packets sourced from the marketing
department to 64 kbps. Drop the packets exceeding the rate limit.
Set the maximum rate of outbound IP packets sent by PC 1 in the R&D
department to 640 kbps. Drop the packets exceeding the rate limit.
II. Network diagram
Figure 1-9 Network diagram for traffic policing and rate limiting configuration
III. Configuration procedure
1) Define an ACL for traffic classification.
# Create ACL 2000 and enter basic ACL view.
<Sysname> system-view
[Sysname] acl number 2000
# Define a rule for the packets with 192.168.0.1 as the source IP address.
[Sysname-acl-basic-2000] rule permit source 192.168.0.1 0
[Sysname-acl-basic-2000] quit
2) Configure traffic policing and rate limiting
# Set the maximum rate of outbound packets sourced from the marketing department
to 64 kbps.
[Sysname] interface Ethernet1/0/2
1-33
Chapter 1 QoS Configuration