H3C S3100-52P Operation Manual page 776

Operation Manual – Information Center
H3C S3100-52P Ethernet Switch
Information channel
3
4
5
6
7
8
9
Note:
Configurations for the six output directions function independently and take effect only
after the information center is enabled.
IV. Outputting system information by source module
The system information can be classified by source module and then filtered. Some
module names and description are shown in
Table 1-3 Source module name list
Module name
8021X
ACL
ADBM
AM
ARP
CMD
DEV
DNS
Default channel
number
trapbuffer
logbuffer
snmpagent
channel6
channel7
channel8
channel9
name
Trap buffer (Receives trap
information, a buffer inside the
device for recording information.)
Log buffer (Receives log
information, a buffer inside the
device for recording information.)
SNMP NMS (Receives trap
information.)
Not specified (Receives log, trap,
and debugging information.)
Not specified (Receives log, trap,
and debugging information.)
Not specified (Receives log, trap,
and debugging information.)
Not specified (Receives log, trap,
and debugging information.)
Table 1-3.
Description
802.1X module
Access control list module
Address base module
Access management module
Address resolution protocol module
Command line module
Device management module
Domain name system module
1-3
Chapter 1 Information Center
Default output direction