Configuring A Mac Address Entry - H3C S3100-52P Operation Manual

Operation Manual – MAC Address Table Management
H3C S3100-52P Ethernet Switch
Enabling Destination MAC Address Triggered Update
Assigning MAC Addresses for Ethernet Ports

1.2.2 Configuring a MAC Address Entry

You can add, modify, or remove a MAC address entry, remove all MAC address entries
concerning a specific port, or remove specific type of MAC address entries (dynamic or
static MAC address entries).
You can add a MAC address entry in either system view or Ethernet port view.
I. Adding a MAC address entry in system view
Follow these steps to add a MAC address entry in system view:
To do...
Enter system view
Add a MAC address
entry
Caution:
When you add a MAC address entry, the port specified by the interface argument
must belong to the VLAN specified by the vlan argument in the command.
Otherwise, the entry will not be added.
If the VLAN specified by the vlan argument is a dynamic VLAN, after a static MAC
address is added, it will become a static VLAN.
II. Adding a MAC address entry in Ethernet port view
Follow these steps to add a MAC address entry in Ethernet port view:
Enter system view
Enter Ethernet port view
system-view
mac-address { static | dynamic |
blackhole } mac-address interface
interface-type interface-number vlan
vlan-id
To do...
system-view
interface interface-type
interface-number
Task
Use the command...
Use the command...
1-6
Chapter 1 MAC Address Table
Management
Remarks
Optional
Optional
Remarks
—
Required
Remarks
—
—