Configuring Associated Devices - H3C S3100-52P Operation Manual

Operation Manual – Smart Link-Monitor Link
H3C S3100-52P Ethernet Switch
Enable the function of
sending flush messages
in the specified control
VLAN
Configure
a port as a
Smart
Link group
member
Follow these steps to configure Smart Link (with link aggregation groups are the
members of the Smart Link group):
Enter system view
Create a Smart Link group
and enter Smart Link
group view
Configure a link
aggregation group as a
member of the Smart Link
group
Enable the function of
sending flush messages
in the specified control
VLAN

1.2.3 Configuring Associated Devices

An associated device mentioned in this document refers to a device that supports
Smart Link and locally configured to process flush messages received from the
specified control VLAN so as to work with the corresponding Smart Link device. As
shown in
active and backup links connecting the Smart Link device (Switch A) and the target
uplink device (Switch E) are all associated devices.
To do...
flush enable control-vlan vlan-id
port interface-type
Smart Link
interface-number { master |
group view
slave }
quit
interface interface-type
Ethernet
interface-number
port view
port smart-link group group-id
{ master | slave }
To do...
system-view
smart-link group
group-id
link-aggregation group
group-id { master |
slave }
flush enable
control-vlan vlan-id
Figure 1-2, all the devices including Switch C, Switch D, and Switch E on the
Chapter 1 Smart Link Configuration
Use the command...
Use the command...
1-5
Remarks
Required
By default, no
control VLAN for
sending flush
messages is
specified.
Required
Use either
approach
Remarks
—
Required
Optional
Optional
By default, no control
VLAN for sending flush
messages is specified.