Configuring Selective Qinq - H3C LS-5100-16P-SI-OVS-H3 Configuration

QinQ
H3C Low-End Ethernet Switches Configuration Examples
Set the TPID in the
outer VLAN tag of
frames
Configure inner-outer
VLAN tag priority
copying
Configure an
inner-outer VLAN tag
priority mapping
Display information
about all
QinQ-enabled ports

1.2.2 Configuring Selective QinQ

Follow these steps to configure selective QinQ:
Enter system view
Enter Ethernet port view
Enable selective QinQ
Specify the outer VLAN
tag to be added to frames
and enter QinQ view
Configure the port to add
the outer VLAN tag to
frames with a specified
inner VLAN ID
Configure inter-VLAN
MAC address replicating
for selective QinQ
To do...
vlan-vpn tpid value
vlan-vpn inner-cos-trust
enable
vlan-vpn priority old-priority
remark new-priority
display port vlan-vpn
To do...
Use the command...
Use the command...
system-view
interface interface-type
interface-number
vlan-vpn enable
vlan-vpn vid vlan-id
raw-vlan-id inbound
vlan-id-list
mac-address-mapping
index source-vlan
source-vlan-list
destination-vlan
dest-vlan-id
1-3
Chapter 1 QinQ Overview
Remarks
Optional
Do not set the TPID to a
protocol value that may
cause conflicts. Some of
such values are listed in
Table 3-1.
By default, the TPID in the
outer VLAN tag is 0x8100
on the H3C series
switches.
Use either command
By default, both
inner-outer VLAN tag
priority copying and
inner-outer VLAN tag
priority mapping are
disabled.
Available in any view
Remarks
—
—
Required
Disabled by default.
Required
Required
Disabled by default.
Required
Disabled by default.