Table of Contents
Advertisement
Protocol type
IPX/SPX
IS-IS
LACP
802.1x
Cluster
Reserved
Protocols and standards
IEEE 802.1Q: IEEE standard for local and metropolitan area networks: Virtual Bridged Local Area
Networks
QinQ configuration task list
Complete the follows tasks to configure QinQ:
Task
Configuring basic QinQ
Setting the TPID value in VLAN tags
NOTE:
QinQ requires configurations only on the service provider network.
•
•
Do not configure QinQ on a reflector port. For more information about reflector ports, see
Management and Monitoring Configuration Guide
Configuring basic QinQ
To enable basic QinQ:
Step
1.
Enter system view.
2.
Enter interface view or port
group view.
3.
Enable QinQ on the
port(s).
NOTE:
Configure basic QinQ on the user-to-network interfaces (UNIs) on service provider network devices that
connect the user networks.
Value
0x8137
0x8000
0x8809
0x888E
0x88A7
0xFFFD/0xFFFE/0xFFFF
.
Command
system-view
•
Enter Layer 2 Ethernet interface view or
Layer 2 aggregate interface view：
interface interface-type
interface-number
•
Enter port group view：
port-group manual port-group-name
qinq enable
98
Remarks
Required
Optional
Network
Remarks
N/A
Use either command.
By default, QinQ is disabled.
Advertisement
Table of Contents
