Displaying And Maintaining Port-Based Vlan; Port-Based Vlan Configuration Example - H3C S3100-52P Operation Manual

Operation Manual – VLAN
H3C S3100-52P Ethernet Switch
Caution:
After configuring the default VLAN for a trunk or hybrid port, you need to use the
port trunk permit command or the port hybrid vlan command to configure the
port to allow traffic of the default VLAN to pass through. Otherwise, the port cannot
forward traffic of the default VLAN, nor can it receive VLAN untagged packets.
The local and remote trunk (or hybrid) ports must use the same default VLAN ID for
the traffic of the default VLAN to be transmitted properly.

2.2.5 Displaying and Maintaining Port-Based VLAN

Display the hybrid or trunk
ports

2.2.6 Port-Based VLAN Configuration Example

I. Network requirements
As shown in
1/Server 2 used by different departments.
To isolate data between different departments, PC 1 and Server 1 are assigned to
VLAN 100 with the descriptive string being Dept1; PC 2 and Server 2 are assigned
to VLAN 200 with the descriptive string being Dept2.
Configure VLAN interfaces for the two VLANs on Switch A for forwarding data
from PC 1 to Server 2 at Layer 3.
To do...
display port { hybrid |
trunk }
Figure 2-1, Switch A and Switch B connect to PC 1/PC 2 and Server
Use the command...
2-6
Chapter 2 VLAN Configuration
Remarks
Available in any view.