Rebooting The Ethernet Switch; Scheduling A Reboot On The Switch - H3C S3100-52P Operation Manual

Operation Manual – System Maintenance and Debugging
H3C S3100-52P Ethernet Switch

4.2.2 Rebooting the Ethernet Switch

You can perform the following operation in user view when the switch is faulty or needs
to be rebooted.
Note:
Before rebooting, the system checks whether there is any configuration change. If yes,
it prompts whether or not to proceed. This prevents the system from losing the
configurations in case of shutting down the system without saving the configurations
Use the following command to reboot the Ethernet switch:
Reboot the Ethernet
switch

4.2.3 Scheduling a Reboot on the Switch

After you schedule a reboot on the switch, the switch will reboot at the specified time.
Follow these steps to schedule a reboot on the switch:
Schedule a reboot on the switch,
and set the reboot date and time
Schedule a reboot on the switch,
and set the delay time for reboot
Enter system view
Schedule a reboot on the switch,
and set the reboot period
Note:
The switch timer can be set to precision of one minute, that is, the switch will reboot
within one minute after the specified reboot date and time.
To do...
reboot [ unit unit-id ]
To do...
Use the command...
Use the command...
schedule reboot at hh:mm
[ mm/dd/yyyy | yyyy/mm/dd ]
schedule reboot delay
{ hh:mm | mm }
system-view
schedule reboot regularity
at hh:mm period
4-2
Chapter 4 Device Management
Remarks
Available in user view
Remarks
Optional
Optional
—
Optional