Chapter 1 Smart Link Configuration; Smart Link Overview; Basic Concepts In Smart Link - H3C S3100-52P Operation Manual

Operation Manual – Smart Link-Monitor Link
H3C S3100-52P Ethernet Switch

Chapter 1 Smart Link Configuration

When configuring smart link, go to these sections for information you are interested in:

Smart Link Overview

Configuring Smart Link
Displaying and Maintaining Smart Link
Smart Link Configuration Example
1.1 Smart Link Overview
As shown in
Spanning Tree Protocol (STP) is used to implement link redundancy backup in the
network. However, STP is not suitable for users with a high demand for convergence
time. Smart Link can achieve active/standby link redundancy backup and fast
convergence to meet the user demand.
Smart Link has the following features:
Active/standby backup for dual-uplink networking
Simple configuration and operation

1.1.1 Basic Concepts in Smart Link

I. Smart Link group
A Smart Link group consists of two member ports, one master port and one slave port.
Normally, only one port (master or slave) is active, and the other port is blocked, that is,
in the standby state. When link failure occurs on the port in active state, the Smart Link
group will block the port automatically and turn standby state to active state on the
blocked port.
uplink
Switch B
Eth1/0/1
Master Port
Figure 1-1 Network diagram of Smart Link
In Figure
Smart Link group.
Figure 1-1, dual-uplink networking is widely applied currently. Usually,
uplink
Switch C
Eth1/0/2
Switch A Slave Port
1-1, Ethernet 1/0/1 and Ethernet 1/0/2 on Switch A are two member ports of a
Chapter 1 Smart Link Configuration
1-1