H3C S3100-52P Operation Manual page 868

Operation Manual – HWPing
H3C S3100-52P Ethernet Switch
Configure the source port
Configure the number of
probes per test
Configure the maximum
number of history records
that can be saved
Configure the packet size
Configure the automatic
test interval
Configure the probe
timeout time
Configure the type of
service
Configure the number of
test packets that will be
sent in each jitter probe
Configure the interval to
send test packets in the
jitter test
Start the test
Display test results
6) Configuring SNMP test on HWPing client
Follow these steps to configure SNMP test on HWPing client:
To do...
source-port port-number
count times
history-records number
datasize size
frequency interval
timeout time
tos value
jitter-packetnum number
jitter-interval interval
test-enable
display hwping results
[ admin-name
operation-tag ]
Use the command...
1-12
Chapter 1 HWPing Configuration
Remarks
Optional
By default, no source port
is configured.
Optional
By default, each test
makes one probe.
Optional
By default, the maximum
number is 50.
Optional
By default, the packet size
is 68 bytes.
Optional
By default, the automatic
test interval is zero
seconds, indicating no
automatic test will be
made.
Optional
By default, a probe times
out in three seconds.
Optional
By default, the service
type is zero.
Optional
By default, each jitter
probe will send 10
packets.
Optional
By default, the interval is
20 milliseconds.
Required
Required
You can execute the
command in any view.