Sftp Configuration: A Switch Operating As An Sftp Server - H3C S3100-52P Operation Manual

Operation Manual – FTP-SFTP-TFTP
H3C S3100-52P Ethernet Switch
SFTP Configuration: A
Switch Operating as an
SFTP Server
SFTP Configuration: A
Switch Operating as an
SFTP Client

1.3.1 SFTP Configuration: A Switch Operating as an SFTP Server

I. Enabling an SFTP server
Before enabling an SFTP server, you need to enable the SSH server function and
specify the service type of the SSH user as SFTP or all. For details, see the SSH server
configuration part of SSH Operation Manual of this manual.
Follow these steps to enable an SFTP server:
Enter system view
Enable an SFTP server
II. Configuring connection idle time
After the idle time is configured, if the server does not receive service requests from a
client within a specified time period, it terminates the connection with the client, thus
preventing a user from occupying the connection for a long time without performing any
operation.
Follow these steps to configure connection idle time:
Enter system view
Configure the connection
idle time for the SFTP
server
Task
Enabling an SFTP server
Configuring connection
idle time
Supported SFTP client
software
Basic configurations on an
SFTP client
Specifying the source
interface or source IP
address for an SFTP client
To do...
system-view
sftp server enable
To do...
system-view
ftp timeout
time-out-value
Chapter 1 FTP and SFTP Configuration
Use the command...
Use the command...
1-17
Remarks
Required
Optional
—
—
Optional
Remarks
—
Required
Disabled by default.
Remarks
—
Optional
10 minutes by default.