Applying A Qos Profile - H3C S3100-52P Operation Manual

Operation Manual – QoS-QoS Profile
H3C S3100-52P Ethernet Switch
To do...
Configure traffic
policing
Configure packet
filtering
Configure priority
marking

2.2.2 Applying a QoS Profile

You can configure to apply a QoS profile dynamically or simply apply a QoS profile
manually.
I. Configuration prerequisites
To configure to apply a QoS profile dynamically, make sure 802.1x is enabled both
globally and on the port, and the authentication mode is determined. For
information about 802.1x, refer to the 802.1x and System Guard module of this
manual.
To apply a QoS profile manually, make sure the port to which the QoS profile is to
be applied is determined.
The QoS profile to be applied is determined.
II. Configuration procedure
Follow these steps to configure to apply a QoS profile dynamically:
Enter system view
Enter Ethernet port view
Use the command...
traffic-limit inbound acl-rule
[ union-effect ] [ egress-port
interface-type interface-number ]
target-rate [ burst-bucket
burst-bucket-size ] [ exceed
action ]
packet-filter { inbound |
outbound } acl-rule
traffic-priority { inbound |
outbound } acl-rule { { dscp
dscp-value | ip-precedence
{ pre-value | from-cos } } | cos
{ pre-value | from-ipprec } |
local-precedence pre-value }*
To do...
Chapter 2 QoS Profile Configuration
Use the command...
system-view
interface
interface-type
interface-number
2-3
Remarks
Optional
Optional
Refer to the ACL module
of this manual for
information about packet
filtering.
Optional
Remarks
—
—