Configuring Traffic Policing - H3C S3100-52P Operation Manual

Operation Manual – QoS-QoS Profile
H3C S3100-52P Ethernet Switch
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.0 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] traffic-priority inbound ip-group 2000 dscp 56
2) Method II
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.0 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] traffic-priority vlan 2 inbound ip-group 2000 dscp 56

1.4.5 Configuring Traffic Policing

Refer to section
I. Configuration prerequisites
The ACL rules used for traffic classification have been defined. Refer to the ACL
module of this manual for information about defining ACL rules.
The rate limit for traffic policing, and the actions for the packets exceeding the rate
limit have been determined.
The ports that need this configuration have been determined.
II. Configuration procedure
Follow these steps to configure traffic policing:
To do...
Enter system view
Enter Ethernet
port view
Configure traffic
policing
Traffic Policing for information about traffic policing.
Use the command...
system-view
interface interface-type
interface-number
traffic-limit inbound
acl-rule [ union-effect ]
[ egress-port interface-type
interface-number ]
target-rate [ burst-bucket
burst-bucket-size ] [ exceed
action ]
1-22
Chapter 1 QoS Configuration
Remarks
—
—
Required
Specify a committed
information rate (CIR) for the
target-rate argument, and
specify a committed bust size
(CBS) for the burst-bucket-size
argument.
By default, traffic policing is
disabled.