H3C S3100-52P Operation Manual page 569

Operation Manual – QoS-QoS Profile
H3C S3100-52P Ethernet Switch
I. Configuration prerequisites
The ACL rules for traffic classification have been defined. Refer to the ACL module
of this manual for information about defining ACL rules.
The source mirroring ports and mirroring direction have been determined.
The destination mirroring port has been determined.
II. Configuration procedure
Follow these steps to configure traffic mirroring:
Enter system view
Enter Ethernet port view
Configure the current port
as a source mirroring port
Quit to system view
Configure the
specified port
as the
destination
mirroring port
Note:
For information about the mirroring-group monitor-port command and the
monitor-port command, refer to the part talking about mirroring.
III. Configuration example
Network requirements:
Ethernet 1/0/1 is connected to the 10.1.1.0/24 network segment.
Duplicate the packets from network segment 10.1.1.0/24 to the destination
mirroring port Ethernet 1/0/4.
Configuration procedure:
To do...
system-view
interface interface-type
interface-number
mirrored-to { inbound |
outbound } acl-rule
{ monitor-interface |
cpu }
quit
mirroring-group group-id
In system
monitor-port
view
monitor-port-id
interface interface-type
In
interface-number
Ethernet
port view
monitor-port
Use the command...
1-31
Chapter 1 QoS Configuration
Remarks
—
—
Required
Omit the following steps
if you redirect traffic to
the CPU.
Proceed to the following
steps if you redirect
traffic to a port.
—
Required
Use either approach.