H3C S3100-52P Operation Manual page 45

Operation Manual – Login
H3C S3100-52P Ethernet switch
Figure 2-4 Set port parameters
3) Turn on the switch. You will be prompted to press the Enter key if the switch
successfully completes POST (power-on self test). The prompt (such as <H3C>)
appears after you press the Enter key, as shown in
Figure 2-5 HyperTerminal CLI
4) You can then configure the switch or check the information about the switch by
executing the corresponding commands. You can also acquire help by typing the ?
character. Refer to related parts in this manual for information about the
commands used for configuring the switch.
Chapter 2 Logging In Through the Console Port
Figure
2-3
2-5.