H3C S3100-52P Operation Manual page 592

Operation Manual – Mirroring
H3C S3100-52P Ethernet Switch
II. Configuration on a switch acting as an intermediate switch
1) Configuration prerequisites
The trunk ports and the remote-probe VLAN are determined.
Layer 2 connectivity is ensured between the source and destination switches over
the remote-probe VLAN.
2) Configuration procedure
Follow these steps to perform configurations on the intermediate switch:
Enter system view
Create a VLAN and enter
VLAN view
Configure the current
VLAN as the
remote-probe VLAN
Return to system view
Enter the view of the
Ethernet port connecting
to the source switch,
destination switch or other
intermediate switch
Configure the current port
as trunk port
Configure the trunk port to
permit packets from the
remote-probe VLAN
Note that an S3100-52P Ethernet switch acting as the intermediate switch in remote
port mirroring networking does not support bidirectional packet mirroring (the both
keyword).
III. Configuration on a switch acting as a destination switch
1) Configuration prerequisites
The destination port and the remote-probe VLAN are determined.
Layer 2 connectivity is ensured between the source and destination switches over
the remote-probe VLAN.
2) Configuration procedure
Follow these steps to configure remote port mirroring on the destination switch:
To do...
system-view
vlan vlan-id
remote-probe vlan
enable
quit
interface interface-type
interface-number
port link-type trunk
port trunk permit vlan
remote-probe-vlan-id
Use the command...
1-7
Chapter 1 Mirroring Configuration
Remarks
—
vlan-id is the ID of the
remote-probe VLAN.
Required
—
—
Required
By default, the port type is
Access.
Required