Configuring Line Rate - H3C S3100-52P Operation Manual

Operation Manual – QoS-QoS Profile
H3C S3100-52P Ethernet Switch
Note:
The granularity of traffic policing is 64 Kbps. If the number you input is in the range of
N*64 to (N+1)*64 (N is a natural number), it will be rounded off to (N+1)*64.
III. Configuration example
Ethernet 1/0/1 of the switch is connected to the 10.1.1.0/24 network segment
Perform traffic policing on the packets from the 10.1.1.0/24 network segment,
setting the rate to 128 kbps
Mark the DSCP precedence as 56 for the inbound packets exceeding the rate
limit.
Configuration procedure:
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.0 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] traffic-limit inbound ip-group 2000 128 exceed
remark-dscp 56

1.4.6 Configuring Line Rate

Refer to section
I. Configuration prerequisites
The port on which line rate configuration is to be performed has been determined.
The target rate and the direction of rate limiting (inbound or outbound) have been
determined.
II. Configuration procedure
Follow these steps to configure line rate:
Enter system view
Enter Ethernet port
view
Line Rate for information about line rate.
To do... Use the command...
system-view
interface interface-type
interface-number
—
—
1-23
Chapter 1 QoS Configuration
Remarks