Configuring Traffic Redirecting - H3C S3100-52P Operation Manual

Operation Manual – QoS-QoS Profile
H3C S3100-52P Ethernet Switch
Configure line rate
III. Configuration example
Configure line rate for outbound packets on Ethernet 1/0/1.
The rate limit is 1,024 Kbps
Configuration procedure:
<Sysname> system-view
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] line-rate outbound 1024

1.4.7 Configuring Traffic Redirecting

Refer to section
I. Configuration prerequisites
The ACL rules used for traffic classification have been defined. Refer to the ACL
module of this manual for information about defining ACL rules.
The traffic redirecting destination has been determined.
The ports that need this configuration have been determined.
II. Configuration procedure
Follow these steps to configure traffic redirecting:
Enter system view
Enter Ethernet port view
Configure traffic
redirecting
To do... Use the command...
line-rate { inbound |
outbound } target-rate
[ burst-bucket
burst-bucket-size ]
Traffic Redirecting
To do...
system-view
interface interface-type
interface-number
traffic-redirect { inbound |
outbound } acl-rule { cpu |
{ interface interface-type
interface-number |
link-aggregation-group
agg-id } [ untagged ] }
for information about traffic redirecting.
Use the command...
1-24
Chapter 1 QoS Configuration
Remarks
Required
Specify a committed
information rate (CIR) for the
target-rate argument, and
specify a committed bust
size (CBS) for the
burst-bucket-size argument.
By default, line rate is
disabled.
Remarks
—
—
Required
By default, traffic
redirecting is not
configured.