H3C S3100-52P Operation Manual page 916

Operation Manual – IPv6 Management
H3C S3100-52P Ethernet Switch
FF02::1:FF00:1
FF02::1:FF49:8048
FF02::1
MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
# Display the brief IPv6 information of the interface on Switch B.
[SwitchB-Vlan-interface2] display ipv6 interface Vlan-interface 2
Vlan-interface2 current state : UP
Line protocol current state : UP
IPv6 is enabled, link-local address is FE80::20F:E2FF:FE00:1
Global unicast address(es):
2001::20F:E2FF:FE00:1, subnet is 2001::/64
3001::2, subnet is 3001::/64
Joined group address(es):
FF02::1:FF00:2
FF02::1:FF00:1
FF02::1
MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
# On Switch A, ping the link-local address, EUI-64 address, and global unicast address
of Switch B. If the configurations are correct, the above three types of IPv6 addresses
can be pinged.
Caution:
When you use the ping ipv6 command to verify the reachability of the destination, you
must specify the "–i" keyword if the destination address is a link-local address. For the
operation of IPv6 ping, refer to section
[SwitchA-Vlan-interface2] ping ipv6 FE80::20F:E2FF:FE00:1 -i Vlan-interface
2
PING FE80::20F:E2FF:FE00:1 : 56
Reply from FE80::20F:E2FF:FE00:1
IPv6 Ping.
data bytes, press CTRL_C to break
1-22
Chapter 1 IPv6 Configuration