Config: Cex (G.703 Clock Extension); Config: Frame (Framing Mode); Config: Framing Mode) Edmac Or Edmac-2 - Comtech EF Data CDM-570 Installation And Operation Manual

CDM-570/570L Satellite Modem with Optional IP Module
Front Panel Operation
5.2.2.1.5

CONFIG: CEx (G.703 Clock Extension)

G703 Clock Extend: None
TxLock RxEnable (◄ ►,ENT)
◄ ►
Use the
Selecting TxLock or RxEnable displays the following submenu:
Clk Extend Interface: T1
E1Bal E1Unbal (◄ ►,ENTER)
Use the ◄ ► arrow keys to select the appropriate G.703 Clock Extension interface – T1, E1Bal,
or E1Unbal – and then press ENTER.
5.2.2.1.6

CONFIG: Frame (Framing Mode)

Framing Mode:
EDMAC EDMAC-2
◄ ►
Use the arrow keys to select Unframed, EDMAC, or EDMAC-2, and then press ENTER.
Note the following:
Selection Description
No framing is selected, no overhead is added, and the modem is with other manufacturers'
Unframed
equipment when operating in a 'standard' configuration.
EDMAC
Comtech EF Data's proprietary framing is added. The framing permits the bi-directional passing of
EDMAC-2 M&C and AUPC data between local and distant-end units.

5.2.2.1.6.1 (CONFIG: Framing Mode) EDMAC or EDMAC-2

EDMAC is backward compatible with the CDM-500, CDM-550, CDM-550T, CDM-600 and
CDM-600L. EDMAC-2 is a reduced overhead version of EDMAC, and while it is not completely
backward compatible with the modems mentioned here, it is backward compatible in some modes
(for example, in Turbo BPSK modes and at rates above 2.048 Mbps).
Selecting EDMAC or EDMAC-2 displays the following submenu:
Framing mix: AUPC-Only
AUPC+EDMAC
Note: When EDMAC or EDMAC-2 framing is enabled, AUPC is automatically enabled but the
specific EDMAC feature (passing M&C data from a local to a distant-end unit) requires further
configuration.
arrow keys to select None, TxLock or RxEnable, and then press ENTER.
Unframed
(◄ ►,ENT)
(◄ ►,ENTER)
5–27
Revision 12
MN/CDM570L.IOM