Unit Parameters - Comtech EF Data CDM-570 Installation And Operation Manual

CDM-570/570L Satellite Modem with Optional IP Module
Appendix K
•
Gain Offset (1:1 Redundancy Only): Select the desired setting from the drop-down menu
•
Amplifier: Select On or Off from the drop-down menu
Down Converter Parameters
•
Frequency: Enter a value in MHz
•
Attenuation: Enter a value in dB
•
Slope Mode: Select Manual or Calibrated from the drop-down menu
•
Slope Adjust (Manual Mode Only): Select the desired setting from the drop-down menu
•
Mute: Select Enabled or Disabled from the drop-down menu
•
Gain Offset (1:1 Redundancy Only): Select the desired setting from the drop-down menu

Unit Parameters

•
Mute Mode: Select Muted after freq change or Unmuted after freq change from the
drop-down menu
•
Auto Fault Recovery or Cold Start: Select Enabled or Disabled from the drop-down
menus
•
Ext Reference Fault Logic: Select Summary or No Summary from the drop-down menu
•
Reference Oscillator Adjust: Enter a value from 0 to 255
LNA Parameters
•
Current Alarm Window: Enter a value of 20 to 50, or 99 to disable this feature
•
Current Source: Select Enabled or Disabled from the drop-down menu
•
Fault Logic: Select Summary or No Summary from the drop-down menu
ODU Circuit Identification
Enter an ODU Circuit Identification name of up to 24 alphanumeric characters.
Click [Submit] to save any changes made to this page.
K–25
Revision 12
MN/CDM570L.IOM