Comtech EF Data CDM-570 Installation And Operation Manual page 326

CDM-570/570L Satellite Modem with Optional IP Module
Ethernet IP Module - CLI and Telnet Operation
Selection
Filtered – Flow Correlator
Filtered – Management
Path
Filtered – WAN Scaling
Filtered – Ping
Filtered – Access Control
Filtered – Vipersat MCP
Filtered – Vipersat UCP
Filtered – Codeload
Filtered – Multicast
Filtered – Bad Packet
Filtered – Route
Filtered – Vipersat
Remote
Filtered – QoS Rule
Filtered – Vipersat Loop
Filtered – Bad Header Len
Filtered – Bad Data Ptr
Filtered – MAC Split Err
Filtered – L3Type Err
Filtered – Local
Destination
Filtered – Redundancy Err
Filtered – ICMP Filter
Filtered – Port Err
Filtered – Per port route
rule
Filtered – Total
Entry Description
Packet are filtered due to improper establishing SAT-to-SAT traffic (This
[RO]
counter generally is seen on outbounding Hub modem in point-to-multipoint
setup)
Not used.
Internal Error occurred during WAN scaling sub process in processing packet.
Ping packets were received but PING feature was disabled.
Packets are received while "Access List" control is enabled but IP address
does not match the access list database.
Internal Error occurred while processing Vipersat Multi-command messages.
Internal Error occurred while processing Vipersat Uni-command messages.
Internal error occurred while processing Codeload messages.
A multicast packet is received but no application is associated with it.
Malformed packet is received. This may be due to internal or external error.
Applies to Vipersat Remote only – when a packet is received from the WAN
and the Route Table contains a route to transmit that packet to the WAN, the
packet is filtered to prevent a routing loop.
Packet filtered due to QoS Rule configured to filter.
Packet filtered due to QoS Rule configured to filter.
Packet are filtered due to Vipersat loop
(a modem configured as a Vipersat Remote Expansion unit and default route
set to 0.0.0.0/0).
Filtered due to packets received with less than 14 bytes of L2 header.
Internal error occurred while accessing the packet data.
Not currently used.
Not currently used.
Packet received with destination MAC as modem MAC and destination IP is
not modem IP while modem is operating in bridge mode (Managed Switch)
Applies to Offline modem in 1:1 Redundancy
Packets are received on the WAN port by the both Offline unit and Online unit,
only Online unit is allowed to forward the packets. Indicates packets received
by Offline unit from WAN port that were filtered because unit is Offline.
This is the same as "Filtered Ping", except this will update in Managed Switch
mode.
Non-IP or ARP packets are targeted to End-station. (End-station will not allow
any non-IP packets).
In 1:1 Redundancy Managed Switch mode – a packet received with modem
destination MAC, but the IP does not match the traffic IP or management IP.
In Router mode – per port WAN filtered mode is ON.
Total Filtered Packets
14–56
Revision 12
MN/CDM570L.IOM