Figure 14-10. Ethernet Interface Page; Ethernet Interface Page - Comtech EF Data CDM-570 Installation And Operation Manual

CDM-570/570L Satellite Modem with Optional IP Module
Ethernet IP Module - CLI and Telnet Operation
14.2.3.1

Ethernet Interface Page

Activate the Ethernet Interface page from the Interface Configuration page.
The Ethernet IP Speed/Mode must be set to match the Ethernet port settings of
the connected device port or there will be a significant performance degradation.
For example, if the connected device port is set for auto negotiate then the IP
Module must also be set to auto negotiate. It is recommended to use auto
negotiate mode unless the connected device port does not support auto
negotiate. In that case, both Ethernet ports must be set to the same Manual
settings (i.e. 100 Mbps Full Duplex).
The Ethernet Interface page contains the following options/fields
Selection
MAC Address
Speed/Mode
IP Address
Subnet Prefix Length
Link Status

Figure 14-10. Ethernet Interface page

Entry Description
[RO] This hardware destination MAC Address is used when an Ethernet
packet is destined for the IP Module Traffic Ethernet Interface. This
address is unique and has been assigned permanently at the factory.
E The Ethernet Speed Mode is a configurable parameter and thus its
exact setting can vary between specific installations. The default setting
allows the Ethernet port to auto negotiate its link speed on power-up.
Selections are:
1 – Auto
2 – 10 MB/sec Half Duplex
3 – 100 MB/sec Half Duplex
4 – 10 MB/sec Full Duplex
5 – 100 MB/sec Full Duplex
I This is the IP Address assigned to the Ethernet Traffic Interface.
Enter the IP address in aaa.bbb.ccc.ddd format
M Specifies the Subnet Mask assigned to the Ethernet Traffic Interface.
Enter the subnet mask prefix length (8...30)
[RO] Displays the current Link Status of the IP Module Traffic port
14–18
Revision 12
MN/CDM570L.IOM