Comtech EF Data CDM-570 Installation And Operation Manual page 409

CDM-570/570L Satellite Modem with Optional IP Module
Appendix E
Command
Parameter (Instruction
Type Code and
Qualifier)
Boot From BLI= 1 byte, value of
Software Image 0,1,2
Base Modem Boot BBI= 1 byte value
From 0,1,2
Param file image PFI= 1 byte, value of 1
to use or 3
Save System SCS= 1 byte value
Configuration
Parameters
Reset Unit RST 1 byte value.
1 - reset the
system.
Restore Factory RFD 1-Byte value
Defaults 1 - restore
Load Params from LPS= 1-Byte value
permanent 1 – load
storage parameters
Arguments for
Command or
Response to
Query
Command or Query.
Image which will be used the next time the system is booted, where:
0=Latest
1=Bulk Image # 1
2=Bulk Image # 2
Example: BLI=1 (which is Image #1 active)
Command or Query.
The binary image, which will be used by the base modem, to boot with.
Where
0 – Latest
1 – Image in Slot# 1
2 – Image in Slot#2.
Example: <1/BBI=0
Command or Query.
Image which will be updated the next time firmware is uploaded to the system:
1=Param1
3=Factory Default
To restore the Factory Defaults, set PFI=3 and issue RST to reset the box. This
would bring up the box with factory default configuration.
Example: PFI =1 (using param image on flash)
Command only
1 – Save config
Setting SCS to '1', will save all the active system configuration on to the Flash.
Command only.
Setting the parameter to 1 resets the system. Telnet2 connection needs to be re-
established.
Command only.
Setting this to '1' will bring the modem back to factory defaults. This may force unit
reboot, depending on the mode of operation.
Command only.
Setting this to '1' loads the system with parameters from permanent storage/flash.
This may force unit reboot, depending on the mode of operation.
Description of Arguments
E–23
Revision 12
MN/CDM570L.IOM
Query
Response to
(Instruction Code
Command
and Qualifier)
BLI = BLI? BLI =x
BLI! (see description of
arguments)
BBI= BBI? BBI=x
BBI! (see description of
arguments)
PFI = PFI? PFI =x
PFI! (see description of
arguments)
SCS= N/A SCS=x
SCS! (see description of
arguments)
RST= N/A RST=x
RST! (see description of
arguments)
RFD= N/A RFD=x
RFD! (see description of
arguments)
LPS= N/A LPS=x
LPS! (see description of
arguments)
Response to
Query