Bulk Commands And Queries - Comtech EF Data CDM-570 Installation And Operation Manual

CDM-570/570L Satellite Modem with Optional IP Module
Appendix D
Command
Parameter (Instruction
Type Code and
Qualifier)
Warm-up Delay WUD= 1 byte,
value 0 or 1
D.6.4

Bulk Commands and Queries

Command
Parameter (Instruction
Type Code and
Qualifier)
OGC Outdoor Unit OGC= 50 Bytes
Global
Configuration
Arguments for
Command or
Response to
Query
Command or Query.
Warm-up Delay for internal frequency reference (OCXO)
0=Disabled (instant on – no delay for OCXO to reach temperature)
1=Enabled (unit waits until OCXO reaches correct temperature)
Example: WUD=1 (selects Warm-up Delay)
Arguments for
Command or
Response to
Query
Command or Query – CDM-570L only.
ODU Global Configuration of CDM-570L in the form
aabcdexxxxhhhhiiiijjjjjkxxxxxxlmnnnooopppppqxxxxxx, where:
aa = BUC Address
b = BUC FSK comms enable
c = BUC Power Control
d = BUC 10MHz Frequency Reference enable
e = BUC Tx Output Enable
xxxx = expansion bytes
hhhh = BUC Low Alarm Limit
iiii = BUC High Alarm Limit
jjjjjk = BUC LO frequency, mix sign
xxxxxx = expansion bytes
l = LNB Power Control
m = LNB 10MHz Frequency Reference enable
nnn = LNB Low Alarm Limit
ooo = LNB High Alarm Limit
pppppq = LNB LO Frequency, mix sign
xxxxxx = expansion bytes
Any unavailable parameters will be filled with xxx.
Description of Arguments
Description of Arguments
same as BAD
same as BCE
same as BPC
same as BFR
same as BOE
same as BCL
same as BCH
same as BLO
same as LPC
same as LFR
same as LCL
same as LCH
same as LLO
D–29
Revision 12
MN/CDM570L.IOM
Query
Response to
(Instruction Code
Command
and Qualifier)
WUD= WUD? WUD=x
WUD? (see Description of
WUD* Arguments)
WUD#
Query
Response to
(Instruction Code
Command
and Qualifier)
OGC= OGC? OGC=aabcdfxxxhhh
OGC? hiiiijjjjjkxxxxxxlmnnn
OGC* ooopppppqxxxxxx
OGC# (see Description of
Arguments)
OGC?n Where n=0 to 9
returns the OGC
portion of 1 of 10
stored
configurations
(see Description of
Arguments)
Response to
Query
Response to
Query