Figure 14-22. Brouter Configuration Page; Brouter Configuration Page - Comtech EF Data CDM-570 Installation And Operation Manual

CDM-570/570L Satellite Modem with Optional IP Module
Ethernet IP Module - CLI and Telnet Operation
Selection
Base
14.2.6.3

Brouter Configuration Page

Activate the Brouter Configuration page from the Protocol Configuration Page.
The Brouter Configuration Page contains the following options/fields:
Selection
VLAN Brouter Mode
VLAN Brouter Tx Payload
Compression
Entry Description
B To allow editing on any of the 256 entries that can be defined (use the ARP
Table menu to view up to 8 different ARP definitions per screen), select a
base address to control which 8 ARP entries are displayed.
For example, if the user wants to edit static ARP Entries 32-40, then a Base
value of 32 should be defined.

Figure 14-22. Brouter Configuration page

Entry Description
Toggle [Enabled] or [Disabled].
B
If enabled, any packet arriving at the Ethernet interface with a VLAN
header is automatically forwarded to the WAN interface. In this mode ALL
VLAN packets are sent – no filtering of any kind.
Brouter Mode may be disabled only when both Brouter
Remote Mode and VLAN Filtering are also disabled. If
selection is attempted while either or both of these features
are enabled, the following message displays:
"Disable VLAN-Filter & Remote Mode, And
Then Disabled Brouter Mode"
Toggle [Enabled] or [Disabled].
P
Enables/disables Payload Compression for all "Brouted" VLAN packets.
14–34
Revision 12
MN/CDM570L.IOM