Comtech EF Data CDM-570 Installation And Operation Manual page 478

CDM-570/570L Satellite Modem with Optional IP Module
Appendix K
(ODU: Enable) KST CONFIG: Transmitter
KST TX: Frequency
Output
Use the ◄ ► arrow keys to select Frequency, Atten, Output, or HPA, and then press
ENTER.
(ODU: Enable) KST CONFIG: KST TX
ODU Tx Frequency:
14500.0 MHz (◄ ►,▲ ▼,ENT)
To edit the transmit frequency: First, use the
then use the
KST-2000A are known and the frequency values are constrained accordingly. Press
ENTER when done.
(ODU: Enable) KST CONFIG: KST TX
ODU Tx Attenuation:
15 dB
To edit the transmit attenuation: First, use the
then use the
(ODU: Enable) KST CONFIG: KST TX
KST Tx Output:
Off
Use the ◄ ► arrow keys to select OFF, ON, or WARM, and then press ENTER. Note
the following:
•
•
•
(ODU: Enable) KST CONFIG: KST TX
HPA:
Use the ◄ ► arrow keys to select State or Fault-Logic, and then press ENTER.
(ODU: Enable) KST CONFIG: KST TX
KST HPA State:
On
Use the ◄ ► arrow keys to select On or Off, and then press ENTER.
Atten
HPA (◄ ►,ENT)
▲ ▼
arrow keys to change the value of that digit. The frequency limits of the
◄ ►,▲ ▼,
(
▲ ▼
arrow keys to change the value of that digit. Press ENTER when done.
◄ ►,E
On Warm (
WARM is OFF, if COLD.
WARM is ON, if warm and NO FAULTS.
If FAULTS are present, stays WARM and OFF indefinitely.
State Fault-Logic
◄ ►,E
(
◄ ►,E
Off (
Frequency
◄ ► arrow keys to select a digit to edit, and
Atten (Attenuation)
ENT)
◄ ► arrow keys to select a digit to edit, and
Output
NT)
HPA
NT)
HPA
NT)
K–16
Revision 12
MN/CDM570L.IOM
State