Config: Tx) Scram (Scrambling) - Comtech EF Data CDM-570 Installation And Operation Manual

CDM-570/570L Satellite Modem with Optional IP Module
Front Panel Operation
(CONFIG: Tx) Output Power Level Mode: AUPC
Remote Demod - Target
Min Eb/No:14.9dB (◄ ►,▲ ▼)
To edit the Remote Demod Target E
edit, and then use the
and the upper limit is 14.9 dB. Press ENTER when done.
(CONFIG: Tx) Output Power Level Mode: AUPC
Maximum-permitted Power
increase: 1dB
Use the
(when in AUPC mode), and then press ENTER. The default value is 1dB, and the
upper limit is 9 dB.
(CONFIG: Tx) Output Power Level Mode: AUPC
Action when max Tx Power
reached: None TxAlarm ◄ ►
Use the
causes the maximum output power level to be reached. Press ENTER when done.
(CONFIG: Tx) Output Power Level Mode: AUPC
Action when Remote Demod
unlocks: Nom-Pwr Max-Pwr
Use the
and then press ENTER.
Note the following:
Selection
Nom-Pwr
Max-Pwr

5.2.2.1.3.8 (CONFIG: Tx) Scram (Scrambling)

Tx Scrambling:Default-On
IESS-315-On Off (◄ ►,ENT)
◄ ►
Use the arrow keys to select Default-On, IESS-315-On, or Off, and then press ENTER.
arrow to edit the value of that digit. The default value is 3.0 dB,
▲ ▼
(▲ ▼,ENT)
arrow keys to edit the value of maximum permitted increase in power level
▲ ▼
◄ ► arrow keys to set the action that occurs – None or TxAlarm – if the AUPC
◄ ► arrow keys to set the action that occurs if the remote demod is unlocked,
Description
(Nominal Power) The output level reverts to the nominal power level set under Manual.
(Maximum Power) The output level changes to the maximum permitted.
◄ ►
/N : First, use the
b 0
5–18
Revision 12
MN/CDM570L.IOM
Target-E /N
b 0
arrow keys to select a digit to
Max-Range
Alarm
DemodUnlock