Comtech EF Data CDM-570 Installation And Operation Manual page 358

CDM-570/570L Satellite Modem with Optional IP Module
Appendix D
Section D.6.X Notes:
1. The remote commands and queries are arranged as subsections of this chapter as follows:
•
Sect. D.6.1 Transmit (Tx) Commands and Queries
•
Sect. D.6.2 Receive (Rx) Commands and Queries
•
Sect. D.6.3 Unit Commands and Queries
•
Sect. D.6.4 Bulk Commands and Queries
•
Sect. D.6.5 BUC Commands and Queries (CDM-570L ONLY)
•
Sect. D.6.6 LNB Commands and Queries (CDM-570L ONLY)
2. A command/query that is unique to the CDM-570L is noted in the 'Parameter Type' column as (CDM-570L ONLY).
Similarly, a command/query that is unique to the CDM-570 is noted in the 'Parameter Type' column as (CDM-570 ONLY).
For commands and queries common to both the CDM-570/570L, any operational difference is noted accordingly in the 'Description of
Arguments' column.
3. The following codes are used in the 'Response to Command' column (see Sect. D.5.5 for further details):
= Message ok
? Received ok, but invalid arguments found
* Message ok, but not permitted in current mode
# Message ok, but unit is not in Remote mode
~ Time out of an EDMAC pass-through message
+ Warning. Command accepted, but other parameters were additionally changed
D–8
Revision 12
MN/CDM570L.IOM