Editing A Cee Switch - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

17

Editing a CEE switch

Editing a CEE switch
1. Select Configure > Switch > CEE from the menu bar.
2. Select the CEE switch from the Products/Ports table.
3. Click Edit.
FIGURE 176
4. Configure the policies for the Edit Switch tabs, which are described in the following sections:
5. When you have finished configuring the policies, apply the settings to the switch.
6. Click OK.
7.
8. Click Start to apply the changes, or click Close to abort the operation.
430
The CEE Configuration dialog box displays, showing the status of all CEE-related hardware and
functions.
The Edit Switch dialog box displays
Edit Switch dialog box
•
"QoS configuration" on page 437
•
"LLDP-DCBX configuration"
•
"Access Control List configuration"
•
"Spanning Tree Protocol configuration"
•
"802.1x authentication"
NOTE
Clicking Cancel when there are pending changes launches a pop-up dialog.
The CEE Confirmation and Status dialog box displays.
Review the changes carefully before you accept them.
(Figure 176).
on page 445
on page 450
on page 455
on page 460
DCFM Enterprise User Manual
53-1001775-01