Viewing And Editing Switch Encryption Properties - Brocade Communications Systems StoreFabric SN6500B Administrator's Manual

2

Viewing and editing switch encryption properties

3. Select a target disk device from the table, then click LUNs.
FIGURE 74

Viewing and editing switch encryption properties

To view switch encryption properties, complete the following steps:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
2. Select a switch or encryption engine from the Encryption Center Devices table, then select
108
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays. (Refer to
The Encryption Target Disk LUNs dialog box displays. The time left for auto rekey information is
listed in the table (Figure
Time left for auto rekey
dialog box. (Refer to Figure 1
Switch/Engine > Properties from the menu task bar, or right-click a switch or encryption engine
and select Properties.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Properties icon.
The Encryption Switch Properties dialog box displays
74).
on page 14.)
Fabric OS Encryption Administrator's Guide (SKM/ESKM)
Figure 43.)
(Figure 75).
53-1002721-01