The Tractor Operation Without The Use Of The Rear Pto Shaft - Belarus 921.6 Operator's Manual

To select required PTO shaft rotation speed, unscrew the bolt 1 by one revolution,
rotate the arm 2 into position I or II and tighten the bolt 1.
ATTENTION: CHANGE THE PTO SHAFT SPEEDS ONLY WHEN THE ENGINE IS
OFF!
Figure 2.17.2 – Switching the PTO shaft rotation speed (view from transmission underside)

2.17.4 The Tractor Operation Without the Use of the Rear PTO Shaft

While operating the tractor without the use of the rear PTO shaft, it is necessary to
place the PTO shaft independent drive arm into position 540 RPM, place the rear PTO
shaft switching handle from the independent to the synchronous drive – into neutral posi-
tion; rear PTO shaft activation lever – into position "PTO is OFF". The protective cap of the
rear PTO shaft shall be installed.
1 – bolt; 2 – arm.
55
921.6-0000010 OM