Belarus 921.6 Operator's Manual page 21

When the lever is pulled as far as it will go (position e, Figure 2.2.3) from position of
the low beam, the high beam will be temporary activated (high beam flashing) regardless
of the main light switch 6 (Figure 2.2.1) position.
The horn will be activated when the lever is pressed in the axial direction (the switch
lever axis). Horn will be activated in any position of the switch lever.
Figure 2.2.3 – Operation scheme of the left steering column multifunction switch
The starter and instruments switch 3 (Figure 2.2.1) has four positions:
- 0 – OFF;
- I – instruments, indicator lamp unit, glow-plugs are ON;
- I – starter is ON (not fixed position);
- III – radio set is ON (counter-clockwise rotation of the key).
The radio set will operate only when the starter and instruments switch is in position I
and III.
Diagram of the starter and instruments switch positions is shown in Figure 2.2.4 and
on the switch instruction plate.
Figure 2.2.4 – Diagram of the starter and instruments switch positions
ATTENTION: THE STARTER CAN BE ACTIVATED AGAIN ONLY AFTER RE-
TURNING THE KEY INTO THE SWITCH POSITION 0. TO MOVE THE STARTER AND
INSTRUMENTS SWITCH INTO POSITION III, IT IS NECESSARY TO PUSH THE KEY
INTO THE SWITH IN POSITION 0, THEN ROTATE IT COUNTER-CLOCKWISE!
Emergency brake light will be activated when the button of the emergency brake
light 4 (Figure 2.2.1) is pressed. Indicator light built-in the button will flash simultaneously
with emergency light. Emergency light will be deactivated when the button 4 is pressed
again.
A
E
C
D
B
21
921.6-0000010 OM