Belarus 921.6 Operator's Manual page 112

-slowly lift the implement and check for clearances between the tractor and imple-
ment in lifted position;
-check for presence of required side swaying of the lower links and adjust if neces-
sary by drawbars.
WARNING: SOME MOUNTED OR SEMI-MOUNTED EQUIPMENT CAN TOUCH
THE CAB AND DAMAGE IT. THIS MIGHT LEAD TO THE CAB'S WINDSHIELD DAMAGE
AND OPERATOR'S INJURIES. CHECK FOR PRESENCE OF SUFFICIENT CLEARANCE
(AT LEAST 100 MM) BETWEEN THE IMPLEMENT IN UPPER POSITION AND THE OP-
ERATOR'S CAB!
ATTENTION: WHEN THE TRACTOR (EQUIPPED WITH LINKS WITH GRIPPERS
MANUFACTURED BY MTZ) IS CONNECTED TO THE MOUNTED OR SEMI-MOUNTED
AGRICULTURAL MACHINES, IT IS OBLIGATORY TO LOCK THE REAR MOUNTED
DEVICE LOWER LINKS GRIPPERS USING THE PIVOT 1 (FIGURE 4.3.7) WITH RING 2!
ATTENTION! WHILE DECOUPLING THE AGRICULTORAL MACHINE FROM THE
TRACTOR IT IS NECESSARY TO REMOVE THE COTTER PIN 5 (WHICH FASTENS THE
JOINT 4 ON THE AGRICULTURAL MACHINE AXIS) FROM THE AGRICULTURAL MA-
CHINE AXIS 6 (FIGURE 4.3.7) AND REMOVE THE PIVOT 1 WITH RING 2 FROM THE
GRIPPER, THEN LIFR THE GRIPPER HANDLE 3 UPWARDS AS FAR AS IT WILL GO.
INSTALL THE PIVOT AND COTTER PIN AS SHOWN IN DETAIL b) OF FIGURE 4.3.7!
a) Position of pivot and cotter pin when
the agricultural machine is connected
1 – pivot; 2 – ring; 3 – gripper handle; 4 – joint; 5 – cotter pin; 6 – agricultural ma-
chine axis.
Figure 4.3.7 – Locking the RMD lower links, manufactured by MTZ
b) Position of pivot and cotter pin when
the agricultural machine is not connected
112
921.6-0000010 OM