Table of Contents
Advertisement
Table 4.4.1 – Main parameters and connecting dimensions of the TSU-ZV (long tow
fork)
Typical size (design)
1 Place of installation
2 Structural features
3 Purpose
4 TH fork dimensions, mm:
a) connecting pivot diameter
1)
b) fork position
for machines driven from the
rear PTO shaft
c) distance from the rear PTO shaft end
face to the connecting pivot axis
5 Coupling device for connection to the TH
a) type
b) vertical load at the hitching point, kN, no
more than
c) turn angle of the machine coupling device
in horizontal plane, degrees, at least
d) type of safety device
e) place for safety device connection on the
tractor
6 Relative calculated value of axial forces (D),
kN, no more than
__________________________________________________________________________________________________
1)
Recommended.
2)
Machine accessory.
ATTENTION: THE TOW FORK SHALL BE DISMOUNTED WHILE WORKING
WITH RMD.FOR THAT PURPOSE UNSCREW 4 BOLTS WITH NUTS (WHICH FASTEN
TO SIDE MEMBERS) AND TAKE YOKE OUT OF THE GUIDES.
ATTENTION:DISMOUNT THE TOW FORK PRIOR TO INSTALLING THE MECH-
ANISM FOR SUSPENSION AXIS LENGTH ADJUSTMENT!
ATTENTION:TO PROVIDE FOR THE TRACTOR SAFE OPERATION WHILE BE-
ING HITCHED WITH THE MOUNTED AGRICULTURAM MACHINES OR TWO-AXLE
TRAILERS, WHICH ARE COUPLED TO THE TOW FORK, IT IS NECESSARY TO
PLACE THE LOWER LINKS OF MD (WITH ANY REAR MOUNTED DEVICE CONFIGU-
RATION) INTO THE MIDDLE POSITION! IT IS PROHIBITED TO LIFT THE MD LOWER
LINKS INTO UPPER POSITION WHILE OWRKING WITH THE TOW FORK!
TSU-ZV (long tow fork)
Rear lifting device, only lower position
of the fork
The mounted agricultural machines
hitching, as well as machines of the
tractor trailer type with hitch rings
Does not provide
Rigid, with hitch ring
Safety chain (rope)
Side wall of the lifting device
117
921.6-0000010 OM
Rotating
30
400
3.5
±60
2)
44.2
Advertisement
Table of Contents
