Show Ipsec Status And Statistics - Digi IX10 User Manual

Virtual Private Networks (VPN)
(config)> vpn ipsec tunnel ipsec_example surelink advanced delayed_
start value
(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set delayed_start to ten minutes, enter either 10m or 600s:
(config)> vpn ipsec tunnel ipsec_example surelink advanced delayed_
start 600s
(config)>
The default is 300s.
g. Set the time to add to the test interval when restarting the list of actions. This option is
capped at 15 minutes.
(config)> vpn ipsec tunnel ipsec_example surelink advanced backoff_
interval value
(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set backoff_interval to ten minutes, enter either 10m or 600s:
(config)> vpn ipsec tunnel ipsec_example surelink advanced backoff_
interval 600s
(config)>
The default is 300 seconds.
h. The interface_gateway parameter is used by the Interface gateway Ping test as the
endpoint for traceroute to use to determine the interface gateway. The default is 8.8.8.8,
and should only be changed if this IP address is not accessible due to networking issues.
To set to an alternate host:
(config)> vpn ipsec tunnel ipsec_example surelink advanced interface_
gateway hostname/IP_address
(config)>
8. Save the configuration and apply the change:
(config vpn ipsec tunnel ipsec_example connection_monitor target 0)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show IPsec status and statistics


Web
IX10 User Guide
IPsec
357