Show Ipsec Status And Statistics - Digi LR54 User Manual

Virtual Private Networks (VPN)
12. Save the configuration and apply the change:
(config vpn ipsec tunnel ipsec_example connection_monitor target 0)> save
Configuration saved.
>
13. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show IPsec status and statistics


Web
1. Log into the LR54 WebUI as a user with Admin access.
2. On the menu, select Status > IPsec.
The IPsec page appears.
3. To view configuration details about an IPsec tunnel, click the  (configuration) icon in the
upper right of the tunnel's status pane.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. To display details about all configured IPsec tunnels, type the following at the prompt:
> show ipsec all
Name
------
ipsec1
vpn1
>
3. To display details about a specific tunnel:
> show ipsec tunnel ipsec1
LR54 User Guide
(config vpn ipsec tunnel ipsec_example surelink target 0)>
other_status value
(config vpn ipsec tunnel ipsec_example surelink target 0)>
where value is either up or down. For example, if other_status is set to
down, but the alternate interface is determined to be up, then this test will
fail.
Enable Status Hostname
------ ------- ---------------
true up 192.168.2.1
false pending 192.168.3.1
IPsec
475