H3C S6550X-HI Series Command Reference Manual page 1885

node 1 permit:
if-match acl 3999
Matches: 0, bytes: 0
node 2 permit:
if-match acl 2000
apply next-hop 2.2.2.2
Matches: 0, bytes: 0
node 5 permit:
if-match acl 3101
apply next-hop 1.1.1.1
Matches: 0, bytes: 0
Total matches: 0, total bytes: 0
Table 4 Command output
Field
Policy based routing information
for local
node 0 deny/node 2 permit
if-match acl
apply next-hop
Matches
bytes
Total matches
total bytes
Related commands
reset ip policy-based-route statistics
display ip policy-based-route setup
Use
display ip policy-based-route setup
Syntax
display ip policy-based-route setup
Description
Local PBR configuration and statistics.
Match mode of the node: permit or deny.
Compares packets with the ACL.
Specifies a next hop for permitted packets.
Number of successful matches on the node.
If the device does not support counting successful matches on a node,
this field displays N/A.
If match counting is disabled on the node, this field is not displayed.
Number of matching bytes on the node.
This field displays N/A if the device does not support counting matching
bytes on a node.
This field is not displayed if match counting is disabled on the node.
Total number of successful matches on all nodes.
This field displays N/A if the device does not support counting
successful matches on a node.
This field is not displayed if match counting is disabled on all nodes.
Total number of matching bytes on all nodes.
This field displays N/A if the device does not support counting matching
bytes on a node.
This field is not displayed if match counting is disabled on all nodes.
to display PBR configuration.
9