H3C S6550X-HI Series Command Reference Manual page 2036

IPv6 policy-based routing commands
apply loadshare
Use
apply loadshare
Use
undo apply loadshare
Syntax
apply loadshare next-hop
undo apply loadshare next-hop
Default
Multiple next hops operate in primary/backup mode.
Views
IPv6 policy node view
Predefined user roles
network-admin
Parameters
next-hop
Usage guidelines
Multiple next hop options operate in either primary/backup or load sharing mode. The following
description uses multiple next hops as an example:
•
Primary/backup mode—A next hop is selected from all next hops in configuration order for
packet forwarding, with all remaining next hops as backups. When the selected next hop fails,
the next available next hop takes over.
•
Load sharing mode—Matching traffic is distributed across the available next hops. If the traffic
does not match any fast forwarding entries, per-packet load sharing is performed. If the traffic
matches a fast forwarding entry, per-flow load sharing is performed.
Examples
# Enable load sharing among multiple next hops.
<Sysname> system-view
[Sysname] ipv6 policy-based-route aa permit node 11
[Sysname-pbr6-aa-11] apply next-hop 1::1 2::2
[Sysname-pbr6-aa-11] apply loadshare next-hop
Related commands
apply next-hop
apply next-hop
Use
apply next-hop
Use
undo apply next-hop
to enable load sharing among multiple next hops.
: Enables load sharing among multiple next hops.
to set next hops.
to remove next hops.
to restore the default.
1