H3C S6550X-HI Series Command Reference Manual page 1945

Field
DN-bit set
Isolation
Condition
State
ISPF
SPF-schedule-interval
Transmit pacing
Default ASE parameters
Route preference
ASE route preference
FRR backup mode
Node-Protecting Preference
Lowest-cost Preference
LSA originated count
LSA received count
SNMP trap rate limit interval: 10 Count: 7
Area count
Stub area count
NSSA area count
ExChange/Loading neighbors
Description
Whether the DN bit is set for OSPFv3 LSAs in the OSPFv3
process.
Whether OSPFv3 isolation is enabled.
Time when the router acts as a stub router:
•
Always.
•
On startup while BGP is converging for xxx seconds,
where xxx is specified by the user.
•
xxx
On startup for
by the user.
State of the stub router:
•
Active.
•
Inactive.
Whether OSPFv3 ISPF is enabled:
•
Enabled.
•
Disabled.
Interval for SPF calculations. If the SPF calculation interval
is fixed, this field also displays in milliseconds enclosed
with brackets.
LSU advertisement rate:
•
Interval—Specifies the interval for sending LSUs.
•
Count—Specifies the maximum number of LSUs sent
at each interval.
Default parameters of redistributed routes. Tag represents
the route tag of the redistributed routes.
Internal route preference.
AS-external route preference.
FRR backup mode:
•
LFA—Uses the LFA algorithm to calculate a backup
next hop for all routes. LFA ABR-only indicates that
only the next hop of the route to the ABR can be used
as the backup next hop.
•
route-policy route-policy-name—Specifies a backup
next hop by using a routing policy.
•
ECMP-shared—Uses the LFA algorithm to calculate a
backup next hop for all routes, including ECMP routes.
Priority of the node-protection backup path selection policy.
Priority of the lowest-cost backup path selection policy.
Number of originated LSAs.
Number of received LSAs.
OSPFv3 can output a maximum of 7 SNMP notifications
within 10 seconds.
Total number of areas.
Number of stub areas.
Number of NSSA areas.
Neighbors in ExChange/Loading state.
11
xxx
seconds, where is specified