H3C S6550X-HI Series Command Reference Manual page 1996

[Sysname] acl ipv6 advanced 3000
[Sysname-acl-ipv6-adv-3000] rule 10 permit ipv6 source 2001::1 128 destination
ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff 128
[Sysname-acl-ipv6-adv-3000] rule 100 deny ipv6
[Sysname-acl-ipv6-adv-3000] quit
[Sysname] ospfv3
[Sysname-ospfv3-1] filter-policy 3000 export
filter-policy import
Use
filter-policy import
LSAs.
Use
undo filter-policy import
Syntax
filter-policy { ipv6
prefix-list-name [ gateway prefix-list-name ] | gateway prefix-list-name |
route-policy route-policy-name } import
undo filter-policy import
Default
Routes calculated using received LSAs are not filtered.
Views
OSPFv3 view
Predefined user roles
network-admin
Parameters
-
ipv6 acl-number
routes by destination.
gateway prefix-list-name
1 to 63 characters, to filter routes by next hop. If you do not specify this option, the command does
not filter routes by next hop.
prefix-list prefix-list-name
string of 1 to 63 characters, to filter routes by destination.
route-policy route-policy-name
string of 1 to 63 characters, to filter received routes.
Usage guidelines
When you specify an ACL, follow these guidelines:
•
If the ACL does not exist or has no rules, OSPFv3 does not filter any calculated routes.
•
If a rule in the ACL is applied to a VPN instance, the rule will deny all calculated routes.
To use an advanced ACL (with a number from 3000 to 3999) in the command, configure the ACL in
one of the following ways:
•
To deny/permit a route with the specified destination, use
permit } ipv6 source sour sour-prefix
to configure OSPFv3 to filter routes calculated using received
to remove the configuration.
-
acl-number [ gateway prefix-list-name ] | prefix-list
: Specifies an IPv6 ACL by its number in the range of 2000 to 3999 to filter
: Specifies an IPv6 prefix list by its name, a case-sensitive string of
: Specifies an IPv6 prefix list by its name, a case-sensitive
: Specifies a routing policy by its name, a case-sensitive
rule [ rule-id ] { deny |
.
62