H3C S6550X-HI Series Command Reference Manual page 1925

route-policy route-policy-name
string of 1 to 63 characters. The command advertises a default route only when a route in the routing
table matches the routing policy.
Usage guidelines
This command enables the interface to advertise a RIPng default route in a route update regardless
of whether the default route exists in the local IPv6 routing table.
A RIPng interface configured to advertise a default route does not receive any default routes from its
neighbors.
Examples
# Configure RIPng on VLAN-interface 100 to advertise only a default route.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ripng default-route only
# Configure RIPng on VLAN-interface 101 to advertise a default route and other routes.
<Sysname> system-view
[Sysname] interface vlan-interface 101
[Sysname-Vlan-interface101] ripng default-route originate
ripng enable
Use
ripng enable
Use
undo ripng enable
Syntax
ripng process-id enable
undo ripng enable
Default
RIPng is disabled on an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
process-id
Examples
# Enable RIPng 100 on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ripng 100 enable
ripng ipsec-profile
Use
ripng ipsec-profile
Use
undo ripng ipsec
to enable RIPng on an interface.
to disable RIPng on an interface.
: Specifies a RIPng process by its ID in the range of 1 to 65535.
to apply an IPsec profile to a RIPng interface.
-
profile
: Specifies a routing policy by its name, a case-sensitive
to remove the IPsec profile from the RIPng interface.
19