H3C S6550X-HI Series Command Reference Manual page 1882

Field
node 0 deny
node 2 permit
if-match acl
apply next-hop
apply output-interface XXXX
Matches
bytes
Total matches
total bytes
Related commands
ip global policy-based-route
display ip policy-based-route interface
Use
display ip policy-based-route interface
and statistics.
Syntax
display ip policy-based-route interface interface-type interface-number
[ slot slot-number ]
Description
has been successfully issued to the driver. The failed status will persist
even after the policy is successfully issued. To clear the failed status,
you must remove the policy and then apply it again.
Match mode of the node, permit or deny.
If a node fails to be issued to the driver, the command displays the
cause in brackets, which include:
•
not support—The device does not support the match criteria
configured on the node.
•
no resource—No sufficient resources (for example, ACLs) are
available for the node.
Compares packets with the ACL.
Specifies a next hop for permitted packets.
Specifies an output interface for permitted packets.
This field displays the interface status in brackets.
•
down—The interface is down at the network layer.
•
inactive—The card that hosts the interface is not in position.
Number of successful matches on the node.
If the device does not support counting successful matches on a node,
this field displays N/A.
If match counting is disabled on the node, this field is not displayed.
If the device does not have sufficient resources to count matches, this
field displays no statistics resource in brackets.
Number of matching bytes on the node.
This field displays N/A if the device does not support counting matching
bytes on a node.
This field is not displayed if match counting is disabled on the node.
Total number of successful matches on all nodes.
This field displays N/A if the device does not support counting
successful matches on a node.
This field is not displayed if match counting is disabled on all nodes.
Total number of matching bytes on all nodes.
This field displays N/A if the device does not support counting matching
bytes on a node.
This field is not displayed if match counting is disabled on all nodes.
6
to display interface PBR configuration