H3C S6550X-HI Series Command Reference Manual page 2179

Parameters
name policy-name
characters.
vlan vlan-id
: Displays QoS policies applied to incoming traffic.
inbound
: Displays QoS policies applied to outgoing traffic.
outbound
Usage guidelines
If you do not specify a direction, this command displays QoS policies applied to VLANs in both the
inbound and outbound directions.
Examples
# Display QoS policies applied to VLAN 2.
<Sysname> display qos vlan-policy vlan 2
Vlan 2
Direction: Inbound
Policy: 1
Classifier: 1
Operator: AND
Rule(s) :
If-match acl 2000
Behavior: 1
Marking:
Remark dscp 3
Committed Access Rate:
CIR 112 (kbps), CBS 5120 (Bytes), EBS 512 (Bytes)
Green action
Yellow action : pass
Red action
Green packets : 0 (Packets) 0 (Bytes)
Yellow packets: 0 (Packets) 0 (Bytes)
Red packets
Classifier: 2
Operator: AND
Rule(s) :
If-match protocol ipv6
Behavior: 2
Accounting enable:
0 (Packets)
Filter enable: Permit
Marking:
Remark dscp 3
Classifier: 3
Operator: AND
Rule(s) :
-none-
Behavior: 3
-none-
: Specifies a QoS policy by its name, a case-sensitive string of 1 to 31
: Specifies a VLAN by its ID in the range of 1 to 4094.
: pass
: discard
: 0 (Packets) 0 (Bytes)
25