H3C S6550X-HI Series Command Reference Manual page 2014

[Sysname-Vlan-interface10] ospfv3 mtu-ignore instance 1
ospfv3 network-type
Use
ospfv3 network-type
Use
undo ospfv3 network-type
Syntax
ospfv3 network-type { broadcast | nbma | p2mp [ unicast ] | p2p } [ instance
instance-id ]
undo ospfv3 network-type [ instance instance-id ]
Default
The network type of an OSPFv3 interface depends on its link layer protocol. For example, if the link
layer protocol is Ethernet, the default network type is broadcast.
Views
Interface view
Predefined user roles
network-admin
Parameters
broadcast
: Specifies the network type as NBMA.
nbma
: Specifies the network type as P2MP.
p2mp
: Specifies the P2MP interface to unicast OSPFv3 packets. By default, a P2MP interface
unicast
multicasts OSPFv3 packets.
: Specifies the network type as P2P.
p2p
instance instance-id
Usage guidelines
If a router on a broadcast network does not support multicast, configure the network type for the
connected interfaces as NBMA.
When the network type of an interface is NBMA or P2MP unicast, you must use the
to specify the neighbor.
When the network type of an interface is P2MP unicast, all OSPFv3 packets are unicast by the
interface.
Examples
# Specify the OSPFv3 network type for VLAN-interface 20 as NBMA.
<Sysname> system-view
[Sysname] interface vlan-interface 20
[Sysname-Vlan-interface20] ospfv3 network-type nbma
Related commands
ospfv3 dr-priority
to specify the network type for an OSPFv3 interface.
: Specifies the network type as broadcast.
: Specifies an instance by its ID in the range of 0 to 255. The default is 0.
to remove the configuration.
80
command
peer