H3C S6550X-HI Series Command Reference Manual page 1975

Down: 0,Init: 0,2-Way: 0,ExStart: 0,Exchange: 0,Loading: 0,Full: 1
Table 22 Command output
Field
Area ID
Down
Attempt
Init
2-Way
ExStart
Exchange
Loading
Full
Total
Sham links'
neighbors(Total:
xx)
display ospfv3 request-queue
Use
display ospfv3 request-queue
Syntax
display
[ interface-type interface-number ] [ neighbor-id ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
process-id
specify an OSPFv3 process, this command displays OSPFv3 request list information for all OSPFv3
processes.
area area-id
to 4294967295 that is translated into the IPv4 address format. If you do not specify an OSPFv3 area,
this command displays OSPFv3 request list information for all areas.
interface-type interface-number
not specify an interface, this command displays OSPFv3 request list information for all interfaces.
Description
Area ID.
In this state, neighbor initial state, the router has not received any information from a
neighboring router for a period of time.
This state is available only in an NBMA network. In this state, the OSPFv3 router has
not received any information from a neighbor for a period. The router can send Hello
packets at a longer interval to keep the neighbor relationship.
In this state, the device received a Hello packet from the neighbor but the packet
contains no router ID of the neighbor. Mutual communication is not setup.
Mutual communication between the router and its neighbor is available. DR/BDR
election is finished under this state (or higher).
In this state, the router decides on the initial DD sequence number and active/standby
relationship of the two parties.
In this state, the router exchanges DD packets with the neighbor.
In this state, the router sends LSRs to request the neighbor for needed LSAs.
LSDB synchronization has been accomplished between neighbors.
Total number of neighbors under the same state.
Statistics about sham links' neighbors. The Total field displays the total number of
neighbors.
ospfv3 [ process-id
: Specifies an OSPFv3 process by its ID in the range of 1 to 65535. If you do not
: Specifies an area by its ID, an IPv4 address or a decimal integer in the range of 0
to display OSPFv3 request list information.
] [ area area-id
: Specifies an interface by its type and number. If you do
41
] request-queue