H3C S6550X-HI Series Command Reference Manual page 2015

ospfv3 peer
Use
ospfv3 peer
Use
undo ospfv3 peer
Syntax
ospfv3 peer ipv6-address [ cost cost
[ instance instance-id ]
undo ospfv3 peer ipv6-address [ instance instance-id ]
Default
No link-local address is specified for the neighbor interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
ipv6-address
cost cost
dr-priority priority
default is 1.
instance instance-id:
0.
Usage guidelines
For NBMA and P2MP interfaces (only when in unicast mode), you must specify the link-local IPv6
addresses of their neighbors because these interfaces cannot find neighbors through broadcasting
hello packets. For NBMA interfaces, you can also specify DR priorities for their neighbors.
Examples
# On VLAN-interface 10, specify the link-local address of its neighbor as FE80::1111.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 peer fe80::1111
ospfv3 prefix-suppression
Use
ospfv3 prefix-suppression
prefixes.
Use
undo ospfv3 prefix-suppression
Syntax
ospfv3 prefix-suppression [ disable ] [ instance instance-id ]
undo ospfv3 prefix-suppression [ instance instance-id ]
Default
Prefix suppression is disabled on an interface.
to specify a neighbor and the DR priority of the neighbor.
to remove the configuration.
: Specifies the link-local IPv6 address of the neighbor.
- : Specifies the cost of the neighbor, in the range of 1 to 65535.
value
: Specifies the DR priority of the neighbor, in the range of 0 to 255. The
Specifies an instance by its ID in the range of 0 to 255. The default is
-
value | dr-priority priority ]
to disable an OSPFv3 interface from advertising all its
to remove the configuration.
81