H3C S6550X-HI Series Command Reference Manual page 1964

Table 13 Command output
Field
Area
Interface ID
Instance ID
IPv6 prefixes
Cost
State
Type
MTU
Priority
Designated router
Backup designated router
Timers
Transmit Delay
FRR backup
FRR TI-LFA
Neighbor count
Primary path detection mode
Adjacent neighbor count
Description
Area ID that the interface belongs to.
Interface ID.
Instance ID.
IPv6 prefix.
Cost value of the interface.
Interface state:
•
DOWN—No protocol traffic can be sent or received on
the interface.
•
Waiting—The interface starts sending and receiving
Hello packets. The router is trying to determine the
identity of the (Backup) designated router for the
network.
•
P-2-P—The interface will send Hello packets at the hello
interval, and try to establish an adjacency with the
neighbor.
•
DR—The router is the designated router on the network.
•
BDR—The router is the backup designated router on the
network.
•
DROther—The router is a DR Other router on the
attached network.
Network type of the interface: PTP (P2P), PTMP (P2MP),
Broadcast, or NBMA.
MTU value of the interface.
DR priority of the interface.
DR on this link.
BDR on this link.
Time intervals in seconds configured on the interface:
•
Hello—Hello interval.
•
Dead—Dead interval.
•
Poll—Polling interval on an NBMA network.
•
Retransmit—LSA retransmission interval.
LSA transmission delay on the interface, in seconds.
Whether LFA calculation is enabled on an interface:
•
Enabled.
•
Disabled.
TI-LFA is not supported in the current software version.
TI-LFA calculation status:
•
Disabled.
•
Enabled.
Number of neighbors on the interface.
Primary link detection mode:
•
BFD ctrl—BFD control packet mode.
•
BFD echo—BFD echo packet mode.
Number of adjacencies on the interface.
30