H3C S6550X-HI Series Command Reference Manual page 1930

ripng summary-address
Use
ripng summary-address
interface.
Use
undo ripng summary-address
Syntax
ripng summary-address ipv6-address prefix-length
undo ripng summary-address ipv6-address prefix-length
Default
No summary network is configured to be advertised through an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
ipv6-address
prefix-length
in the range of 0 to 128. It indicates the number of consecutive 1s of the prefix, which defines the
network ID.
Usage guidelines
Networks on the summary network will not be advertised. The cost of the summary route is the
lowest cost among summarized routes.
Examples
# Assign an IPv6 address with the 64-bit prefix to VLAN-interface 100 and configure a summary with
the 35-bit prefix.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 address 2001:200::3EFF:FE11:6770/64
[Sysname-Vlan-interface100] ripng summary-address 2001:200:: 35
timer triggered
Use
timer triggered
Use
undo timer triggered
Syntax
timer
[ incremental-interval ] ]
undo timer triggered
Default
The maximum, minimum, and incremental intervals for sending triggered updates are 5 seconds, 50
milliseconds, and 200 milliseconds, respectively.
to configure a summary network to be advertised through an
: Specifies the destination IPv6 address of the summary route.
: Specifies the prefix length of the destination IPv6 address of the summary route,
to set the interval for sending triggered updates.
to restore the default.
triggered maximum-interval
to remove a summary network.
24
[ minimum-interval